Ipv6 Nd Ns-Interval (Bng) - Cisco ASR 9000 Series Command Reference Manual

ipv6 nd ns-interval (BNG)

ipv6 nd ns-interval (BNG)
To configure the interval between IPv6 neighbor solicitation retransmissions on an interface, use the ipv6 nd
ns-interval command in an appropriate configuration mode. To restore the default interval, use the no form
of this command.
ipv6 nd ns-interval milliseconds
no ipv6 nd ns-interval
Syntax Description
milliseconds
Command Default
0 milliseconds (unspecified) is advertised in router advertisements, and the value 1000 is used for the neighbor
discovery activity of the router itself.
Command Modes
Interface configuration (not applicable for BNG)
Dynamic template configuration (for BNG)
Command History
Release
Release 3.7.2
Release 4.3.0
Usage Guidelines
This value is included in all IPv6 router advertisements sent out from this interface. Very short intervals are
not recommended in normal IPv6 operation. When a nondefault value is configured, the configured time is
both advertised and used by the router itself.
For BNG, ensure you run this command in the dynamic template configuration mode. To enter the dynamic
template configuration mode, run dynamic-template command in the Global Configuration mode.
Task ID
Task ID
ipv6
network
config-services
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
360
Interval (in milliseconds) between IPv6 neighbor solicit transmissions. Range
is 1000 to 3600000.
Modification
This command was introduced.
This command was supported in the dynamic template configuration
mode for BNG.
Operations
read, write
read, write
read, write
Neighbor Discovery Commands