Unicast-Qos-Adjust - Cisco ASR 9000 Series Command Reference Manual

unicast-qos-adjust

unicast-qos-adjust
To configure the IGMP QOS Shaper for subscriber unicast traffic, use the unicast-qos-adjust command in
the IGMP configuration mode. To disable this feature, use the no form of this command.
unicast-qos-adjust{adjustment-delay| download-interval| holdoff}
no unicast-qos-adjust
Syntax Description
adjustment-delay
download-interval
holdoff
Command Default
None
Command Modes
IGMP configuration mode
Command History
Release
Release 4.2.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Use the dynamic-template type ppp command to enter dynamic template type ppp configuration mode.
Task ID
Task ID
multicast
Examples This is an example of configuring the unicast-qos-adjust command in the IGMP configuration mode:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# router igmp
RP/0/RSP0/CPU0:router(config-igmp)# unicast-qos-adjust
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
344
Configures the time to wait before programming rate in QOS.
Configures the time before downloading a batch of interfaces to QOS.
Configures the hold-off time before QOS clears the stale entries.
Modification
This command was introduced.
Operation
read, write
Multicast Commands