Ipv6 Nd Framed-Prefix-Pool - Cisco ASR 9000 Series Command Reference Manual

Neighbor Discovery Commands

ipv6 nd framed-prefix-pool

To set the IPv6 Neighbor Discovery (ND) framed prefix pool, use the ipv6 nd framed-prefix-pool command
in the dynamic template configuration mode. To disable the framed prefix pool configuration, use the no form
of this command.
ipv6 nd framed-prefix-pool pool_name
no ipv6 nd framed-prefix-pool
Syntax Description
pool_name
Command Default
None
Command Modes
Dynamic template configuration
Command History
Release
Release 4.3.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
This value is included in all IPv6 router advertisements sent out from this interface. Very short intervals are
not recommended in normal IPv6 operation. When a nondefault value is configured, the configured time is
both advertised and used by the router itself.
To enter the dynamic template configuration mode, run dynamic-template command in the Global
Configuration mode.
Task ID
Task ID
config-services
Examples This example creates an IPv6 framed prefix pool in the dynamic template configuration mode:
RP/0/RSP0/CPU0:router(config)# dynamic-template type ppp p1
RP/0/RSP0/CPU0:router(config-dynamic-template-type)# ipv6 nd framed-prefix-pool pool1
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
Specifies the framed address pool name.
Modification
This command was introduced.
Operations
read, write
ipv6 nd framed-prefix-pool
5.2.x
357