Service-Policy (Qos-Bng) - Cisco ASR 9000 Series Command Reference Manual

service-policy (QoS-BNG)

service-policy (QoS-BNG)
To enable the QoS policy on a parent S-VLAN, or to enable ingress and egress VLAN policies on an
access-interface, use the service-policy command in the interface configuration mode. To disable this feature,
use the no form of this command.
Egress S-VLAN Policy:
service-policy output service_policy_name subscriber-parent [resource-id value ]
no service-policy output service_policy_name subscriber-parent [resource-id value ]
Ingress and Egress VLAN Policies:
service-policy {input | output} service_policy_name
no service-policy {input | output} service_policy_name
Syntax Description
input
output
service_policy_name
subscriber-parent
resource-id
value
Command Default
None
Command Modes
Interface configuration
Command History
Release
Release 4.2.0
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
484
Attaches the specified service-policy to the ingress
direction.
Attaches the specified service-policy to the egress
direction.
Name of the input or output service-policy.
Configures an S-VLAN policy.
This keyword applies only to the egress
Note
direction.
Specifies a resource ID that allows to map the desired
chunk to be used for this S-VLAN and all the
subscribers under it.
This keyword applies only to an S-VLAN
Note
policy and not to VLAN policy.
The resource ID value that ranges from 0-3.
Modification
This command was introduced.
QOS Commands