Lpts Punt Excessive-Flow-Trap Penalty-Rate - Cisco ASR 9000 Series Command Reference Manual

Excessive Punt Flow Trap Commands

lpts punt excessive-flow-trap penalty-rate

To set the penalty policing rate for a protocol, use the lpts punt excessive-flow-trap penalty-rate command
in Global Configuration mode. To restore the default penalty-rate, use the no form of this command.
lpts punt excessive-flow-trap penalty-rate{trace| arp| icmp| dhcp| pppoe| ppp| igmp| ip| l2tp| all| interface|
information } penalty_rate
no punt excessive-flow-trap penalty-rate{trace| arp| icmp| dhcp| pppoe| ppp| igmp| ip| l2tp| all| interface|
information }
Syntax Description
default
arp
icmp
dhcp
pppoe
ppp
igmp
ip
l2tp
penalty_rate
Command Default
None
Command Modes
Global Configuration mode
Command History
Release
Release 4.3.0
Usage Guidelines
No specific guidelines impact the use of this command.
Sets the default penalty policing rate for all protocols.
Sets the penalty policing rate for the ARP protocol.
Sets the penalty policing rate for the ICMP protocol.
Sets the penalty policing rate for the DHCP protocol.
Sets the penalty policing rate for the PPPoE protocol.
Sets the penalty policing rate for the PPP protocol.
Sets the penalty policing rate for the IGMP protocol.
Sets the penalty policing rate for the IPv4 protocol.
Sets the penalty policing rate for the L2TP protocol.
Penalty rate in packets per second (pps).
The range, in pps, is from 2 to 100; default is 10.
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
lpts punt excessive-flow-trap penalty-rate
Modification
This command was introduced.
5.2.x
255