Virtual-Mac - Cisco ASR 9000 Series Command Reference Manual

Subscriber Commands

virtual-mac

To configure the virtual MAC explicitly for a specific subscriber redundancy group(SRG), while BNG being
in master redundancy mode, use the virtual-mac command in subscriber redundancy group configuration
sub-mode. To remove this configuration, use the no form of this command.
virtual-mac virtual-mac
no virtual-mac virtual-mac
Syntax Description
virtual-mac
Command Default
None
Command Modes
Subscriber redundancy group configuration.
Command History
Release
Release 5.2.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
The usage guidelines of this command remain the same as that for virtual-mac-prefix command.
Task ID
Task ID
config-services
Examples This example shows how to configure virtual MAC explicitly for an SRG in a subscriber redundancy feature
scenario in BNG:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# subscriber redundancy
RP/0/RSP0/CPU0:router(config-subscr-red)# group 1
RP/0/RSP0/CPU0:router(config-subscr-red-gr)# virtual-mac 0001.0002.0001
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
Virtual MAC address.
Modification
This command was introduced.
Operation
read, write
virtual-mac
5.2.x
535