Ipsubscriber Session-Limit - Cisco ASR 9000 Series Command Reference Manual

ipsubscriber session-limit

ipsubscriber session-limit
To limit the number of IP subscriber sessions on a subscriber interface, use the ipsubscriber session-limit
command in the interface configuration mode. To disable this feature, use the no form of this command.
ipsubscriber session-limit{total| unclassified-source}per-vlan session_limit
no ipsubscriber session-limit
Syntax Description
total
unclassified-source
per-vlan
session-limit
Command Default
None
Command Modes
Interface configuration mode
Command History
Release
Release 4.3.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
Task ID
network
Examples This is an example of configuring the ipsubscriber session-limit command in the interface configuration
mode:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# interface Bundle-Ether 56
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
284
Limits IP subscribers for all sources.
Limits IP subscribers for unclassified sources.
Limits the per VLAN subscribers.
Specifies the maximum number to which of the IP subscriber session
can be limited.
Modification
This command was introduced.
Operation
read, write
IPoE Commands