Lpts Punt Excessive-Flow-Trap - Cisco ASR 9000 Series Command Reference Manual

lpts punt excessive-flow-trap

lpts punt excessive-flow-trap
To activate the Excessive Punt Flow Trap feature and to enter the control plane policer configuration mode,
use the lpts punt excessive-flow-trap command in Global Configuration mode. To exit the control plane
policer configuration mode and disable the Excessive Punt Flow Trap feature, use the no form of this command.
lpts punt excessive-flow-trap{subscriber-interfaces| non-subscriber-interfaces| penalty-rate|
penalty-timeout}
no lpts punt excessive-flow-trap{subscriber-interfaces| non-subscriber-interfaces| penalty-rate|
penalty-timeout}
Syntax Description
subscriber-interfaces
non-subscriber-interfaces
penalty-rate
penalty-timeout
Command Default
None
Command Modes
Global Configuration mode
Command History
Release
Release 4.3.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
Task ID
config-services
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
252
Enables the Excessive Punt Flow Trap for subscriber interfaces.
Enables the Excessive Punt Flow Trap for non-subscriber
interfaces.
Sets the penalty policing rate for a protocol.
Sets the penalty timeout for a protocol.
Modification
This command was introduced.
Operations
read, write
Excessive Punt Flow Trap Commands