Show Lpts Punt Excessive-Flow-Trap Interface - Cisco ASR 9000 Series Command Reference Manual

show lpts punt excessive-flow-trap interface

show lpts punt excessive-flow-trap interface
To display the penalty status of an interface for one or all protocols, use the show lpts punt excessive-flow-trap
interface command in the EXEC mode.
show lpts punt excessive-flow-trap interface type interface-path-id [protocol ]
Syntax Description
type
interface-path-id
protocol
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
266
Specifies the interface type. For more information, use the question mark (?) online help
function.
Either a physical interface instance or a virtual interface instance:
• Physical interface instance. Naming notation is rack/slot/module/port and a slash
between values is required as part of the notation.
◦ rack: Chassis number of the rack.
◦ slot: Physical slot number of the modular services card or line card.
◦ module: Module number. A physical layer interface module (PLIM) is always
0.
◦ port: Physical port number of the interface.
In references to a Management Ethernet interface located on a route processor
Note
card, the physical slot number is alphanumeric (RSP0 ) and the module is
CPU0. Example: interface MgmtEth0/RSP0 /CPU0/0.
• Virtual interface instance. Number range varies depending on interface type.
For more information about the syntax for the router, use the question mark (?) online help
function.
Specifies the protocol type.
• arp—Displays ARP bad actors.
• icmp—Displays ICMP bad actors.
• dhcp—Displays DHCP bad actors.
• pppoe—Displays PPPoE bad actors.
• ppp—Displays PPP bad actors.
• igmp—Displays IGMP bad actors.
• ipv4—Displays IPv4 bad actors.
• l2tp—Displays L2TP bad actors.
• all—Displays bad actors for all protocols.
Excessive Punt Flow Trap Commands