Cisco Asr 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference - Cisco ASR 9000 Series Command Reference Manual

IPv4 and IPv6 Commands
Command History
Release
Release 3.7.2
Release 4.2.0
Usage Guidelines
The show ipv4 interface command provides output similar to the show ipv6 interface command, except that
it is IPv4-specific.
The interface name will be displayed only if the name belongs to the VRF instance. If the vrf-name is not
specified then the interface instance will be displayed only if the interface belongs to the default VRF.
Task ID
Task ID
ipv4
network
Examples This is the sample output of the show ipv4 interface command:
RP/0/RSP0/CPU0:router# show ipv4 interface
Loopback0 is Up, line protocol is Up
Internet address is 10
.0.0.1/8
Secondary address 10.0.0.2/8
MTU is 1514 (1514 is available to IP)
Multicast reserved groups joined: 10.0.0.1
Directed broadcast forwarding is disabled
Outgoing access list is not set
Inbound
Proxy ARP is enabled
ICMP redirects are always sent
ICMP unreachables are always sent
gigabitethernet0/0/0/0 is Up, line protocol is Up
Internet address is 10.25.58.1/16
MTU is 1514 (1500 is available to IP)
Multicast reserved groups joined: 10.0.224.1
Directed broadcast forwarding is disabled
Outgoing access list is not set
Inbound
Proxy ARP is enabled
ICMP redirects are always sent
ICMP unreachables are always sent
gigabitethernet0/0/0/0 is Shutdown, line protocol is Down
Vrf is default (vrfid 0x60000000)
Internet protocol processing disabled
This table describes the significant fields shown in the display.
access list is not set
access list is not set
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
Modification
This command was introduced.
This command was supported for BNG.
Operations
read
read
show ipv4 interface (BNG)
5.2.x
313