Show Pool Ipv6 Name - Cisco ASR 9000 Series Command Reference Manual

show pool ipv6 name

show pool ipv6 name
To show the status of an IPv6 pool, use the show pool ipv6 name command in the EXEC mode.
show pool ipv6 name pool_name{location| verbose| }
Syntax Description
pool_name
location
verbose
|
Command Default
None
Command Modes
EXEC mode
Command History
Release
Release 4.3.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes the proper task
IDs. If you suspect user group assignment is preventing you from using a command, contact your AAA
administrator for assistance.
Use thepool ipv6 command to enter Pool IPv6 configuration submode.
Task ID
Task ID
ip-services
Examples This is the sample output for the show pool ipv6 name command:
RP/0/RSP0/CPU0:router# show pool ipv4 name POOL_A6_i_1
---------------------------------------------------
VRF: vrf1
Pool Id: 1
Pool Scope: VRF Specific Pool
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
102
Specifies the name of the IPv6 pool.
Specifies the location of the IPv6 pool.
Displays all allocations for the pools.
Specifies the output modifiers.
Modification
This command was introduced.
Pool POOL_A6_i_1 Allocations
Address Pool Service Commands
Operation
read