Cisco ASR 9000 Series Command Reference Manual page 499

QOS Commands
Release
Release 4.3.0
Release 4.3.1
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes the proper task
IDs. If you suspect user group assignment is preventing you from using a command, contact your AAA
administrator for assistance.
If the resource-id option is not specified, then the S-VLAN policy and all the subscribers under it are assigned
to the default chunk, which its parent interface is associated with.
The VLAN policy needs to be attached to the access interfaces, before bringing up the sessions with the QoS
policy. It is recommended that you do not remove VLAN policies when sessions are already active.
You cannot make non-rate modifications when sessions are already active on the access-interface. To make
non-rate modifications to the VLAN policy, you must bring down the sessions that are brought up over the
access-interface, modify the policy, and then bring up the sessions again over the access-interface.
Task ID
Task ID
qos
Examples This example shows how to configure an egress S-VLAN policy using the service-policy command, with
subscriber-parent keyword, in the interface configuration mode:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# interface bundle-ether 18.12
RP/0/RSP0/CPU0:router(config-subif)# service-policy output svlan-policy subscriber-parent
resource-id 1
This example shows how to configure an ingress VLAN policy on an access-interface:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# interface bundle-ether 18.203
RP/0/RSP0/CPU0:router(config-subif)# service-policy input mark
This example shows how to configure an egress VLAN policy on an access-interface:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# interface bundle-ether 18.203
RP/0/RSP0/CPU0:router(config-subif)# service-policy output metering
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
Modification
Support for the resource-id keyword was added.
Support for the ingress and egress VLAN policies
on an access interface was added.
Operation
read, write
service-policy (QoS-BNG)
5.2.x
485