Address-Pool - Cisco ASR 9000 Series Command Reference Manual

BNG DHCP Commands

address-pool

To specify the name of an address pool by integrating the DHCPv6 sever with distributed address pool service
(DAPS), use the address-pool command in the DHCP IPv6 server profile class configuration mode. To
remove the address pool name, use the no form of this command.
address-pool pool_name
no address-pool pool_name
Syntax Description
pool_name
Command Default
None
Command Modes
DHCP IPv6 server profile class configuration
Command History
Release
Release 4.3.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
To enter the DHCP IPv6 server profile configuration, enter profile profile_name server command in the
DHCPv6 configuration mode.
To enter the DHCP IPv6 server profile class configuration, enter class class_name command in the DHCPv6
server profile configuration mode.
Task ID
Task ID
ip-services
Examples This is an example of creating a address-pool name using the address-pool command:
RP/0/RSP0/CPU0:router(config)# dhcp ipv6
RP/0/RSP0/CPU0:router(config-dhcpv6)# profile my_profile server
RP/0/RSP0/CPU0:router(config-dhcpv6-server-profile)# class class_dhcp
RP/0/RSP0/CPU0:router(config-dhcpv6-server-profile-class)# address-pool pool_addr
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
Specifies the name of a address pool.
Modification
This command was introduced.
Operations
read, write
address-pool
5.2.x
141