Debug Ilpower - Cisco catalyst 3750 Command Reference Manual

debug ilpower

debug ilpower
Use the debug ilpower privileged EXEC command to enable debugging of the power controller and
Power over Ethernet (PoE) system. Use the no form of this command to disable debugging.
Syntax Description
cdp
controller
event
ha
port
powerman
registries
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History Release
12.1(19)EA1
12.2(25)SE
Usage Guidelines This command is supported only on PoE-capable switches.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you can start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member. You
also can use the remote command stack-member-number LINE privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
Related Commands Command
show controllers power inline
show power inline
Catalyst 3750 Switch Command Reference
B-14
debug ilpower {cdp | controller | event | ha | port | powerman | registries}
no debug ilpower {cdp | controller | event | ha | port | powerman | registries}
Display PoE Cisco Discovery Protocol (CDP) debug messages.
Display PoE controller debug messages.
Display PoE event debug messages.
Display PoE high-availability messages.
Display PoE port manager debug messages.
Display PoE power management debug messages.
Display PoE registries debug messages.
Modification
This command was introduced.
The cdp, ha, and powerman keywords were added.
Appendix B
Description
Displays the values in the registers of the specified PoE controller.
Displays the power status for the specified PoE port or for all PoE
ports.
Catalyst 3750 Switch Debug Commands
OL-8552-07