Table of Contents
Advertisement
20
en | Getting started
3.2.3
Check/Upload the devices firmware
All (new) PRAESENSA network devices are delivered with firmware. Initial, the network
devices are delivered with factory firmware and need to be upgraded. All devises need to be
upgraded to the latest available online version.
The device firmware is incorporated in the *.zip file as described in (Mandatory) software,
page 16 .
–
Caution!
Do not connect the configuration PC to a port of any other device on the same network, such
!
as the (Advantech) PRA-ES8P2S Ethernet switch or any other Ethernet switch.
You have two firmware upload possibilities:
1.
2.
1. 1
At 1
results in NO configuration (logon) access.
Upload process:
1.
2.
3.
4.
5.
6.
2020-09 | V1.20 | PRAESENSA 1.20
The following procedure is valid for installing updates and new releases of the network
device firmware. See the online PRAESENSA release notes for updates and new releases.
See Related documentation, page 7 .
st
1
time firmware upload (without a secured connection):
–
Only valid in case of 1
–
No (logon) configuration web pages present, yet.
Secure firmware upload (with a secured connection).
–
Only possible after 1
–
(Logon) configuration web pages are available.
st
time firmware upload
st
time / initial use of PRAESENSA, the devices firmware must be uploaded. Not to do so
Check and/or download the latest available software (firmware) version release:
See (Mandatory) software, page 16 .
–
On your PRAESENSA configuration computer browse to, and run "SetupOMNEOFirmware
UploadTool(64).exe": (select the 32‑bit or 64‑bit version)
–
Follow the onscreen instructions.
Click the Yes button or the NO button if you do not want to proceed.
–
Yes opens the screen where all connected network device types are visible (see the
selection tabs on the top of the screen).
–
The Firmware Upload Tool (FWUT) addresses the devices via their device hostname.
See Logon the application, page 35 .
Select a tab and then select one or more (for all rows on the screen > Windows > ctrl A
>) device rows and click the Upload button.
–
The screen Select Firmware for upload becomes visible.
–
The model name (the commercial type number) of the selected device type is/are
listed.
Select the (latest) Firmware version to upload.
Click the Start button or the Cancel button if you do not want to proceed.
–
Start will continue the firmware upload process.
–
The State column will show active or finish.
–
The Progress column will show the upload progress (green color bar).
–
The error LED on the 19" device front panel is on (yellow) as long the upload process
of the device runs.
st
time / initial firmware upload.
st
time / initial firmware upload and 1
Configuration manual
PRAESENSA
st
time configuration logon.
Bosch Security Systems B.V.
Advertisement
Table of Contents
