Station Number Setting - Mitsubishi Electric GOT2000 Series Connection Manual

14.5.3

Station number setting

Set each station number so that no station number overlaps.
The station number can be set without regard to the cable connection order. There is no problem even if station numbers
are not consecutive.
• When connecting the GOT and servo amplifier with RS-232
Set the station number (axis number) of the servo amplifier connected to the GOT to 0. Set the station numbers (axis
numbers) of other servo amplifiers connected to the GOT to other than 0.
• When connecting the GOT and servo amplifier with RS-485
The GOT will be the station number (axis number) 0. Set the station numbers (axis numbers) of other connected servo
amplifiers to other than 0.
Example of RS-232 connection between GOT-servo amplifier
■1. Direct specification
When setting the device, specify the station number of the servo amplifier of which data is to be changed.
MINAS A4, MINAS A4F, MINAS A4L
■2. Indirect specification
When setting the device, indirectly specify the station number of the inverter of which data is to be changed using the
16-bit GOT internal data register (GD10 to GD25).
When specifying the station No. from 100 to 115 on drawing software, the value of GD10 to GD25 compatible to the
station No. specification will be the station No. of the servo amplifier.
Specification
Station No.
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
14 - 14
14.5 Servo Amplifier Side Setting
Station Station
No.0 No.7
GOT
Examples of station number setting
Model name
MINAS A5
Compatible
device
GD10
GD11
GD12
GD13
GD14
GD15
GD16
GD17
GD18
GD19
GD20
GD21
GD22
GD23
GD24
GD25
Station Station Station
No.1 No.15 No.6
• MINAS A4, MINAS A4F, MINAS A4L
0 to 15
• MINAS A5
0 to 31
For the setting other than the above, a communication timeout error will occur.
Specification range
0 to 15
0 to 31
Setting range