Mitsubishi Electric GOT2000 Series Connection Manual page 488

■2. Communication detail settings
Make the settings according to the usage environment.
GOT Net No.
*1
GOT Station
GOT Communication Port No.
Retry
Startup Time
Timeout Time
Delay Time
*1
■3. GOT Ethernet Setting
The GOT can be connected to a different network by configuring the following setting.
(1) GOT IP address setting
Set the following communication port setting.
• Standard port (When using GT25-W, port 1)
• Extension port (When using GT25-W, port 2)
(2) GOT Ethernet common setting
Set the following setting which is common to the standard port and the extension port, or port 1 and port 2.
• [Default Gateway]
• [Peripheral S/W Communication Port No.]
• [Transparent Port No.]
(3) IP filter setting
By configuring the IP filter setting, the access from the specific IP address can be permitted or shut off.
For the detailed settings, refer to the following manual.
➠
12 - 14
12.3 Ethernet Connection
Item
Set the network No. of the GOT.
(Default: 1)
Set the station No. of the GOT.
(Default: 1)
Set the GOT port No. for the connection with the Ethernet
module.
(Default: 5022)
Set the number of retries to be performed when a
communication timeout occurs. When receiving no response
after retries, the communication times out. (Default: 3times)
Specify the time period from the GOT startup until GOT starts
the communication with the PLC CPU. (Default: 3sec)
Set the time period for a communication to time out. (Default:
3sec)
Set the delay time for reducing the load of the network/
destination PLC. (Default: 0ms)
Each of [GOT Station] set in the communication detail setting and [Station] set in the Ethernet setting must be set to different
station numbers.
➠ ■4.
Ethernet setting
1.1.2 GOT Ethernet Setting
Description Range
1 to 239
1 to 254
1024 to 5010, 5014 to 65534
(Except for 5011 to 5013 and
49153 to 49170)
0 to 5times
3 to 255sec
1 to 90sec
0 to 10000
( 10ms)