Device Range That Can Be Set - Mitsubishi Electric GOT2000 Series Connection Manual

3.6

Device Range that Can Be Set

The device ranges of controller that can be used for GOT are as follows.
Note that the device ranges in the following tables are the maximum values that can be set in GT Designer3.
The device specifications of controllers may differ depending on the models, even though belonging to the same series.
Please make the setting according to the specifications of the controller actually used.
When a non-existent device or a device number outside the range is set, other objects with correct device settings may not
be monitored.
■1. Setting item
For Azbil SDC/DMC Series
Item
Device
Information
Network
Switch to the device
define dialog
*1
3 - 72
3.6 Device Range that Can Be Set
Set the device name, device number, and bit number.
The bit number can be set only when specifying the bit of word device.
Displays the device type and setting range which are selected in [Device].
Set the monitor target of the set device.
To monitor the control equipment of the specified station No.
• When Azbil SDC/DMC Series is used.
0 to 127
200 to 215 :To specify the station No. of the control equipment to be monitored by the value of GOT
Station data register (GD).
• When Azbil DMC50 is used.
1 to 15: To specify the station No. of the COM module or control equipment to be monitored.
100 to 115: To specify the station No. of the COM module or control equipment to be monitored, and
the Sub Station of the control equipment by the value of GOT data register (GD).
Specify the sub station number of the control equipment connected to the COM module specified in
[Station] to monitor it. (0 to 15)If the specified [SubStation] is 0, the COM module/control equipment
Sub Station
specified in [Station] is monitored.
For AHC2001, the sub station number is ignored.
Device definition can be checked.
The following shows the relation between station numbers of the control equipment and the GOT data register.
Station No.
200
201
:
214
215
Description
:To monitor the control equipment of the specified station No.
*1
GOT data register (GD)
GD10
GD11
:
GD24
GD25
For Azbil DMC50
*2
Setting range
0 to 127
(If setting a value outside the range
above, a device range error occurs.)