Mitsubishi Electric GOT2000 Series Connection Manual page 32

Graphic operation terminal
Hide thumbs Also See for GOT2000 Series:
Table of Contents

Advertisement

■2. Setting item
This section describes the setting items of the Manufacturer, Controller Type, Driver and I/F.
When using the channel No.2 to No.4, put a check mark at [Use CH*].
Item
Use CH*
Manufacturer
Type
I/F
Driver
Detail Setting
(1) Setting [Driver]
The displayed items for a driver differ according to the settings [Manufacturer], [Controller Type] and [I/F].
When the driver to be set is not displayed, confirm if [Manufacturer], [Controller Type] and [I/F] are correct.
For the settings, refer to the following.
1 - 4
1.1 Setting the Communication Interface
Select this item when setting the channel No.2 to No.4.
Select the manufacturer of the equipment to be connected to the GOT.
Select the type of the equipment to be connected to the GOT. For the settings, refer to the following.
(2)Setting [Controller Type]
Select the interface of the GOT to which the equipment is connected. For the settings, refer to the following.
(3)Setting [I/F]
Select the communication driver to be written to the GOT. For the settings, refer to the following.
(1)Setting [Driver]
Make settings for the transmission speed and data length of the communication driver.
Refer to each chapter of the equipment to be connected to the GOT.
[Setting the communication interface] section in each chapter
Description

Advertisement

Table of Contents
loading

Table of Contents