Mitsubishi Electric GOT2000 Series Connection Manual page 431

10.5.4 Station No. settings
Set each station number so that no station number overlaps.
The station number can be set without regard to the cable connection order. There is no problem even if station numbers
are not consecutive.
■1. Direct specification
When setting the device, specify the station number of the indicating controller of which data is to be changed.
■2. Indirect specification
When setting the device, indirectly specify the station number of the indicating controller of which data is to be changed
using the 16-bit GOT internal data register (GD10 to GD25).
When specifying the station No. from 100 to 115 on GT Designer3, the value of GD10 to GD25 compatible to the
station No. specification will be the station No. of the indicating controller.
Specification station NO.
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
■3. All station specification
Target station differs depending on write-in operation or read-out operation.
• For write-in operation, all station will be a target.
In the WORD BIT write-in operation, only the indicating controller whose station No. is the same as host address is
applicable. For details of host address setting, refer to the following.
➠
10.4.1 Setting communication interface (Communication settings)
• In the read-out operation, only the indicating controller whose station No. is the same as host address is applicable.
For details of host address setting, refer to the following.
➠
10.4.1 Setting communication interface (Communication settings)
Station Station
No.3 No.7
GOT
Examples of station number setting
Specification range
0 to 94
Compatible device
GD10
GD11
GD12
GD13
GD14
GD15
GD16
GD17
0 to 94
For the setting other than the above, error (dedicated device is out of range) will occur.
GD18
GD19
GD20
GD21
GD22
GD23
GD24
GD25
Station Station Station
No.1 No.15 No.6
Setting range
10.5 Indicating Controller Side Setting
10
10 - 19