Communication Detail Settings - Mitsubishi Electric GOT2000 Series Connection Manual

9.4.2

Communication detail settings

Make the settings according to the usage environment.
Item
Set this item when change the transmission speed used for communication with the connected
Transmission Speed equipment.
(Default: 19200bps)
Set this item when change the data length used for communication with the connected
Data Bit equipment.
(Default: 7bits)
Specify the stop bit length for communications.
Stop Bit
(Default: 2bit)
Specify whether or not to perform a parity check, and how it is performed during communication.
Parity
(Default: Even)
Set the number of retries to be performed when a communication error occurs.
Retry
(Default: 0time)
Specify the time period from the GOT startup until GOT starts the communication with the PLC
Startup Time CPU.
(Default: 3sec)
Set the time period for a communication to time out.
*1
Timeout Time
(Default: 3sec)
Set this item to adjust the transmission timing of the communication request from the GOT.
Delay Time
(Default: 0ms)
*1 When connecting to the communication port, set "Delay Time" of the GOT side to 30ms or more.
POINT POINT POINT
(1) Communication interface setting by the Utility
(2) Precedence in communication settings
Description
The communication interface setting can be changed on the Utility's [Communication
Settings] after writing [Communication Settings] of project data.
For details on the Utility, refer to the following manual.
➠ GOT2000 Series User's Manual (Utility)
When settings are made by GT Designer3 or the Utility, the latest setting is effective.
Range
4800bps, 9600bps,
19200bps
7bit (fixed)
2bit (fixed)
Even (fixed)
0 to 5times
3 to 30sec
3 to 30sec
0 to 300ms
9.4 GOT Side Settings
9
9 - 11