Connecting To Directlogic 205 Series - Mitsubishi Electric GOT2000 Series Connection Manual

Graphic operation terminal
Hide thumbs Also See for GOT2000 Series:
Table of Contents

Advertisement

7.5.4

Connecting to DirectLOGIC 205 series

■1. Communication settings
Make the following settings using the programmer system parameter setting.
Protocol
Station No.
*1
Transmission speed
Data bit
Stop bit
Parity
Self-diagnostic mode
Response delay time
Peer to Peer
Master/Slave
Timeout
Transmission mode
MODBUS
*1
7.5.5
Connecting to PZ Series
■1. Communication settings
Make the following settings using the programmer system parameter setting.
Protocol
Timeout
Response delay time
Station No.
Communication format
*1
Transmission speed
Stop bit
Parity
*1
7 - 28
7.5 PLC Side Setting
Item
Indicates only the transmission speeds that can be set on the GOT side.
Set the same transmission speed of the GOT.
For the transmission speed setting on the GOT side, refer to the following.
7.4.1 Setting communication interface (Communication settings)
Item
Indicates only the transmission speeds that can be set on the GOT side.
Set the same transmission speed of the GOT.
For the transmission speed setting on the GOT side, refer to the following.
7.4.1 Setting communication interface (Communication settings)
CCM NET (DirectNET)
1 to 90
9600bps, 19200bps, 38400bps
8bits (fixed)
1bit (fixed)
NONE, ODD
OFF
0ms
OFF
Slave
Enable
HEX
OFF
CCM NET
800ms/960ms/1200ms/1600ms/4000ms/8000ms/16000ms/40000ms
0ms
1 to 90
HEX
9600bps, 19200bps, 38400bps
1bit
NONE, ODD
Set value
Set value

Advertisement

Table of Contents
loading

Table of Contents