INSTALLATION GUIDE > Printer Assembly > Assembling the Stands and the Device
Issue
Model
CJV300
4.2 Assembling the Stands and the Device
Work procedures
Right leg 1
Left leg 2
Right leg 2
Front side
Front side
Right leg 2
Leg stay
Leg stay
Roll guide BKT B
Roll guide BKT A
[TS model]
Roll guide BKT R
© 2014 MIMAKI ENGINEERING CO.,LTD.
Revised
2014.09.01
1. Fix the right leg 2 to the right leg 1 with the 6 screws (M5x15).
right : Red label
left : Blue label
2. Fix the leg stay to the leg with the 12 screws (M5x15).
Temporary
tightening
3. Fix the roll guide BKT A/B to the leg with the 10 screws
Roll guide BKT A
Roll guide BKT B
F/W ver. 1.30 Remark
Assemble the other side as the same.
Be sure to assemble, matching the color of the
labels attached on the leg1 and 2.
Assemble the right leg 1 and left leg 1 correctly.
[Front view]
Left leg 1
Temporarily fasten the upper screws on the rear
leg stay.
Use the provided hexagonal wrench.
For the tank tray, make sure that the tank tray is
assembled after the assembling of accessories is
completed. Otherwise, it may cause an injury by
catching a foot or so.
Hold down the leg stay and fix it.
Direction to press
(M5x15).
When fixing the roll guide BKT, press it in the
direction of the arrow and tighten the screws.
Direction to press
Rev.
1.0
1
2
Right leg 1
3
4
5
Direction to press
6
7
Direction to press
4.2
R.1.0
P.3