SATO CL4NX Operator's Manual page 760

Pin I/O Description
No.
Print Done/Print End signal (PREND)
6 Output
Outputs a signal when the media print is
completed.
Reprint signal (PRIN2)
7 Input
Prints the previously printed content again
when a low signal is detected.
8 Input External power supply
Offline
9 Output
Outputs a low signal when the printer is in
Offline mode.
Ribbon Near End
10 Output
Outputs a high signal when the ribbon near
end is detected.
11 - -
12 - +24 V ± 10%
13 - Vcc +5 V
14 - -
Wait signal for dispense completion
* Output
Outputs a low signal when the dispense is
completed.
You can set the pin number for output
through the [Settings] > [Interface] >
[External I/O] > [Signals] > [Outputs] menu.
Label Near End signal
* Output
Outputs a high signal when the label near
end is detected.
You can set the pin number for output
through the [Settings] > [Interface] >
[External I/O] > [Signals] > [Outputs] menu.
*This feature is supported on printers from
serial number 6B~ and above.
Electric Conditions
(Voltage, Current (Max))
Withstand voltage 50 V
Sink current 50 mA
High: high impedance
Low: more than -15 mA, 0 V
5 V
Withstand voltage 50 V
Sink current 50 mA
Withstand voltage 50 V
Sink current 50 mA
-
2 A
500 mA
-
Withstand voltage 50 V
Sink current 50 mA
Withstand voltage 50 V
Sink current 50 mA
760
External Signal (EXT) Interface