SATO CL4NX Operator's Manual page 13

Using the head
cleaning fluid
Laser beam
Print head
Do not use in
hazardous locations
Do not place in areas
with high humidity
Carrying the printer
• Use of flame or heat around the head cleaning fluid is prohibited.
Absolutely do not heat it or subject it to flames.
• Keep the fluid out of reach of children to prevent them from
accidentally drinking it. If a child accidentally drinks the fluid,
immediately consult with a physician.
• Do not look into the laser radiation window, and do not direct the
laser beam at someone. If the laser beam hits eyes, it may cause
visual disturbance.
• The print head is hot after printing. Be careful not to get burned when
replacing media or cleaning immediately after printing.
• Touching the edge of the print head with bare hands could result in
injury. Be careful not to become injured when replacing media or
cleaning.
• The customer should not replace the print head. Doing so could
result in injury, burns or electric shock.
• The printer is not explosion proof certified.
• Do not use in a potentially explosive environment or atmosphere.
• Do not place the printer in areas with high humidity or where
condensation forms. If condensation forms, immediately turn off the
power switch and do not use the printer until it dries. Using the printer
while condensation is on it could result in electric shock.
• When moving the printer, always unplug the power cord from the
outlet and check to make sure all external wires are disconnected
before moving it. Moving the printer with the wires still connected
could damage the cords or connecting wires and result in a fire or
electric shock.
• Do not carry the printer with media loaded in it. The media could fall
out and cause an injury.
• When setting the printer on the floor or a stand, be sure not to get
your fingers or hands pinched under the printer feet.
• Do not carry the printer with the barcode checker stand installed. The
barcode checker stand could fall out and cause injury.
13