SATO CL4NX Operator's Manual page 427

Select the printer's memory space in which to store forms, graphics and fonts.
The options are as follows:
Internal RAM
Use the printer's RAM. The data will be lost if the printer is powered off.
Internal FLASH
Use the printer's flash memory.
Front USB
Use the USB memory connected to the USB connector (Type A) on the front side of the printer.
Rear USB
Use the USB memory connected to the USB connector (Type A) on the rear side of the printer.
• Be sure to perform a virus check on the USB memory before connecting it to the
printer. SATO Corporation shall not be held responsible for any printer malfunctions
caused by a virus spread via USB memory.
[Sim. 300 DPI Head]
When you are using the printer with 305 dpi resolution, enable or disable 300 dpi simulation mode.
The options are as follows:
Enabled
Enable 300 dpi simulation mode. The sizes and positions of objects such as lines, boxes and
barcodes in the print data are automatically adjusted to the equivalent 300 dpi sizes and positions
for printing.
Disabled
Disable 300 dpi simulation mode.
427