SATO CL4NX Operator's Manual page 458

Darkness Adjust
Fine tune the print darkness of the test print.
0 is the lightest and 99 is the darkest.
• The value of [Label Length], [Pitch], [Offset] and [Darkness Adjust] set in the [Configure
List] will be reflected to the same item settings in the [Factory] menu, [Configure QR]
menu and [Paper Sensor] menu.
[Configure QR]
Print the printer setting information with a QR code.
1. Check and set the items as listed on the [Configure QR] menu.
2. Press the
print.
To stop the test print, first pause the print and then press the
The setting items are as follows:
Label Width
Shows the necessary media width of the test print.
The necessary media width is 50.8 mm (2") for [Small].
Label Length
Set the length of one piece of the media used for the test print.
The setting range varies depending on the print resolution of the printer.
The setting range is as follows:
Resolution
203 dpi
button to start the test print. Press the
CL4NX
400 to 1600 dots
button.
CL6NX
400 to 1600 dots
458
[Test Print]
button again to pause the