SATO CL4NX Operator's Manual page 456

[Configure List]
Print the printer setting information.
1. Check and set the items as listed on the [Configure List] menu.
2. Press the
print.
To stop the test print, first pause the print and then press the
The setting items are as follows:
Label Width
Shows the necessary media width of the test print.
The necessary media width is 50.8 mm (2") for [Small].
Label Length
Set the length of one piece of the media used for the test print.
The setting range varies depending on the print resolution of the printer.
The setting range is as follows:
Resolution
203 dpi
(1 dot = 0.125 mm
(0.0049"))
305 dpi
(1 dot = 0.083 mm
(0.0033"))
609 dpi
(1 dot = 0.042 mm
(0.0017"))
button to start the test print. Press the
CL4NX
400 to 1600 dots
600 to 2400 dots
1200 to 4800 dots
button.
CL6NX
400 to 1600 dots
600 to 2400 dots
-
456
[Test Print]
button again to pause the