[Backfeed] - SATO CL4NX Operator's Manual

Dispenser
Peel the liner from the printed label as the label is fed to the printer's front. Once the printed label
has been removed from the printer for application, the next label will retract and position itself for
printing. You can specify this option only if you have installed the dispenser unit.
Linerless (CL4NX only)
Cut each label while printing the specified number of labels. You can specify this option only if you
have installed the linerless cutter kit.
• If no option is installed, [Continuous] and [Tear-Off] are available.
• If the optional cutter unit is installed, [Continuous], [Tear-Off], [Cutter], and [Cut & Print]
are available.
• If the optional dispenser unit is installed, [Continuous], [Tear-Off], and [Dispenser] are
available.
• If the optional linerless cutter kit is installed to CL4NX, only [Linerless] is available.
• You cannot set the [Print Mode] if [Auto-mode] is [Enabled].

[Backfeed]

[Backfeed] is applicable only when the print mode is set to tear-off mode, cutter mode, cut & print
mode, dispenser mode or linerless mode (CL4NX only).
The options are as follows:
None
Do not backfeed.
After
After cut, backfeed the front part of the next media to the print head position. For dispenser mode,
backfeed the front part of the next label after dispensing the label.
Before
Before printing, backfeed the front part of the next media to the print head position.
227