SATO CL4NX Operator's Manual page 691

Hide thumbs Also See for CL4NX:

Table of Contents

5. Press the lever (2) to remove the print head (3).

For CL4NX UHF RFID models, the UHF RFID antenna is installed on the print head.

Be careful not to overly pull the antenna cable when replacing the print head. Contact

your SATO reseller, dealer, or technical support center for more information.

6. Disconnect all the connectors (4) from the defective print head (3).

In total, there are two connectors for CL4NX and three connectors for CL6NX.

7. Connect all the connectors (4) to the new print head.

Handle the print head with care. Do not contaminate or scratch the sensitive print head

8. Install the new print head.

Install the print head so that it is locked with a click sound.

9. Load the media and ribbon back if you remove them in step 4.