SATO CL4NX Operator's Manual page 460

Resolution
(1 dot = 0.083 mm
(0.0033"))
609 dpi
(1 dot = 0.042 mm
(0.0017"))
When you decrease the setting value, the stop position moves in the feed direction (toward the
front part of the media).
When you increase the setting value, the stop position moves opposite the feed direction (toward
the end part of the media).
Darkness Adjust
Fine tune the print darkness of the test print.
0 is the lightest and 99 is the darkest.
• The value of [Label Length], [Pitch], [Offset] and [Darkness Adjust] set in the [Configure
QR] will be reflected to the same item settings in the [Factory] menu, [Configure List]
menu and [Paper Sensor] menu.
[Paper Sensor]
Print the detection result of the media sensor level.
1. Check and set the items as listed on the [Paper Sensor] menu.
2. Press the
print.
To stop the test print, first pause the print and then press the
The setting items are as follows:
CL4NX
-90 to 0 to 90 dots
button to start the test print. Press the
CL6NX
-
button.
460
[Test Print]
button again to pause the