SATO CL4NX Operator's Manual page 521

Hide thumbs Also See for CL4NX:

Table of Contents

For the CL4NX RFID model, the position of the I-mark sensor becomes a minimum

of 0.3 mm (0.01") when the position of the gap sensor is adjusted to around 7.3 mm

(0.3"). Because of this, the paper end may be frequently detected when the [Advanced]

> [Paper End] of the [Printing] menu is set to [Using I-mark] (the default), due to the

shifting of the media or other causes. When you have adjusted the position of the Gap

sensor to around 7.3 mm (0.3"), change [Paper End] to [Using Gap].