SATO CL4NX Operator's Manual page 545
Hide thumbs
Also See for CL4NX:
- Programming reference manual (756 pages) ,
- Operator's manual (384 pages) ,
- Service manual (160 pages)
Table of Contents
Advertisement
Operation 18: Cutter Mode, No Backfeed, and with Pulse Input (Head Check
Enabled)
Operation
*1 Because backfeeding is not done, the media in this area is not printable.
•
The figure above shows the reference position when the Gap sensor is used.
Timing Chart
*1 Keep the PRIN signal until the PREND signal is outputted.
545
Advertisement
Table of Contents
