Ieee1284 Interface Connection (Standard) - SATO CL4NX Operator's Manual

Hide thumbs Also See for CL4NX:

Table of Contents

To use the RS-232C interface to connect with the computer, the printer's [Interface] >

[RS-232C] > [Interface] menu must be set to [RS-232C].

The interface settings of the computer can be confirmed by the following. In the Device

Manager, right-click [Ports] > [Communications Port (COM1)] and select [Properties].

Then, check the [Port Settings] tab of the displayed Properties screen.

For the RS-232C cable, note that the connection cable varies according to the

communication protocol setting. If you use the wrong cable, it will not operate correctly.

If the communication settings differ between the computer and printer, it will not

operate correctly. A communication error will be detected.

To use the printer driver, the communication protocol must be set to Status4. (The

initial value of the communication protocol for the printer's RS-232C interface is

Be sure to use the recommended RS-232C cable.

Printing using the USB serial conversion cable is not guaranteed. Also, no support for

the connection procedure is provided.

IEEE1284 Interface Connection (Standard)

Connect the interface cable when the printer is powered off.

Connect the IEEE1284-compliant cable to the IEEE1284 connector (1) of the printer.

IEEE1284 Interface Connection (Standard)