[Print Mode] - SATO CL4NX Operator's Manual

When using [Auto-mode], the print mode changes automatically according to the status of the installed
option unit.
The options are as follows:
Enabled
The print mode changes automatically.
Disabled
The print mode changes according to the setting of the [Print Mode].
• Operate in cutter mode if you have installed the optional cutter unit.
• Operate in dispenser mode if you have installed the optional dispenser unit.
• Operate in linerless mode if you have installed the optional linerless cutter kit (CL4NX
only).

[Print Mode]

Set the print mode.
The options are as follows:
Continuous
Continuously print the specified number of the media. The media remains in position for printing at
all times.
Tear-Off
After continuously printing the specified number of the media, feed the media to the point to
remove the media. After printing, tear off the media manually. The media will be back to the print
head position for starting the next printing.
Cutter
Cut each media while printing the specified number of media. You can specify this option only if
you have installed the cutter unit.
Cut & Print
Allows you to continuously print and cut at the specified media repeat. If no print data is received
within the period specified for [Eject Cut], the printer will feed the media to the cut position and cut
the last printed media. You can specify this option only if you have installed the cutter unit.
226
[Print Mode]