SATO CL4NX Operator's Manual page 280

Hide thumbs Also See for CL4NX:

Table of Contents

You can connect a maximum of 10 devices.

When Wi-Fi Direct is active, [Device Name] cannot be changed.

[Start Group] and [Remove Group] are shown only if Wi-Fi is active and the printer is

not connected to a Wi-Fi Direct network.

[Remove Group] is shown if Wi-Fi is active and the printer is connected.

After setting up a start group, the printer will be set to the GO (Group Owner) and will

wait for a connection request from another device.

If the printer is powered off during a persistent group connection, the group will be

started automatically after the printer is powered on.

Set the SSID.

The screen shows the Wi-Fi network detected by the printer.

Select the name of the Wi-Fi network you want to connect using the

button to confirm.

To register a Wi-Fi network manually, press the

You can enter a maximum of 32 characters. Alphabets (capital and small letters), numbers and

symbols can be used.

button and enter the name of the network.

buttons and press the