Print Mode - SATO CL4NX Operator's Manual

Print Mode

You can change the print mode of the printer according to its usage and installed options.
The printer has the following print modes:
[Continuous]
Prints the specified number of media. The media remains in position for printing at all times.
[Tear-Off]
After printing the specified number of media, the printer feeds the last printed media so that it is
fully extended out of the printer's front for removal. After printing, tear off the media manually. The
media will be back to the print head position to start the next printing.
[Cutter]
Cuts each media while printing the specified number of media. You can specify this option only if
you have installed the cutter unit.
[Cut & Print]
Allows you to continuously print and cut at the specified media repeat. If no print data is received
within the period specified for [Eject Cut], the printer will feed the media to the cut position and cut
the last printed media. You can specify this option only if you have installed the cutter unit.
[Dispenser]
Peels the liner from the printed label as the label is fed to the printer's front. Once the printed label
has been removed from the printer for application, the next label will retract and position itself for
printing. You can specify this option only if you have installed the dispenser unit.
[Linerless] (CL4NX only)
Cuts each label while printing the specified number of labels. You can specify this option only if
you have installed the linerless cutter kit.
• You cannot set the [Print Mode] if [Auto-mode] is [Enabled].
Change the print mode according to the following procedure:
98
Print Mode