Configuring Optional Barcode Check Function; Basic Specifications Of The Barcode Check Function - SATO CL4NX Operator's Manual

Configuring Optional Barcode Check Function

Basic Specifications of the Barcode Check Function

The barcode check function does a reading check of a barcode printed by this printer to prevent the
distribution of labels with defective barcodes. You can use this function by installing the supported
barcode checkers to the printer.
The basic specifications of the barcode check function are as follows:
Item
Supported Barcode
Checkers
Supported Commands
Supported Print Modes
Print Speed/Print
Darkness
Printable Area
(Barcode Readable Area)
Specification
• IDEC/DATALOGIC WB1F-100S1S (for 1D barcodes, USB
connection)
• IDEC/DATALOGIC GFS4470 (for 1D barcodes/2D codes, USB
connection)
• KEYENCE BL-1301 (for 1D barcodes, RS-232C connection)
• KEYENCE SR-710 (for 1D barcodes/2D codes, RS-232C
connection)
Refer to the manual of the barcode checker for its settings and
supported barcodes.
SBPL/SZPL/SIPL/STCL/SDPL/SEPL
• AEP is not supported.
Continuous/Cutter/Cut & Print/Dispenser/Linerless (CL4NX only)
• Not available in Tear-Off mode.
• Not available for CL4NX RFID models.
• The Void Print function is not available in Dispenser/
Linerless (CL4NX only) mode.
The optimal print speed and print darkness for secure reading vary
depending on various conditions, such as the barcode type and label
layout. Be sure to perform a test read carefully and determine the
settings.
Same as the printer specifications. However, there are following
restrictions:
625