SATO CL4NX Operator's Manual page 191

Hide thumbs Also See for CL4NX:

Table of Contents

Load the media from the rear of the printer

Load the media from the bottom of the printer.

When loading the media, make sure that the print side faces up.

5. Pull the tab (7) of the cutter unit in the direction A, and then open up the cutter-

open lever to (B).

6. Pass the media below the media damper (8) and media sensor guide (9) and

through the cutter unit while pushing the media to inside of the printer.

Make sure that the end of the media extends out the front of the printer.