SATO CL4NX Operator's Manual page 645

Hide thumbs Also See for CL4NX:

Table of Contents

Linerless (CL4NX only)

The barcode check is not performed if the position at which the check starts is detected after the

label feeding begins to stop. Define the label layout and position at which the check starts by

keeping in mind that the distance required for stopping is proportional to the print speed.

Printed barcodes or 2D codes can be read only with a size at which their entire pattern is within

the scanning range of the barcode checker. A reading error may occur depending on the print

This function cannot be controlled through the use of external signals (EXT).

Restrictions When Using GFS4470

By the double-reading prevention function, the barcode checker may not read barcodes that are

printed successively if they are within the readable area. Adjust the print position so that same

barcodes are not within the readable area.

When printing composite symbols that use GS1 DataBar, the read data and print data never

match if the barcode data is 16 digits or less. A comparison error occurs in comparison mode.

Though "\" (0x5C) specified in MAXI code, print data should be read as "\\" in the specifications.

However, it may not be read as such, depending on the following data. For example, "\A"

specified in print data should be read as "\\A" in the specifications, but it is actually read as only

Restrictions When Using WB1F-100S1S

Multiple barcodes cannot be read at the same time.

When NUL (0x00) is included in CODE128 print data, only the data before NUL is recognized

as reading data, and NUL and the data after NUL are ignored. A comparison error occurs in

comparison mode. In readable mode, a reading error occurs only if NUL is specified at the

beginning of the print data.

Ranges to be avoided

Cutting according to the specified number of labels

Approximately 44 mm (1.73") from the print end position

No restriction

Approximately 25 mm (0.98") from the print end position