SATO CL4NX Operator's Manual page 233

Head Check
Check if there is a broken element of the print head.
Head Check Mode
Set the mode for head check.
◦ Appears only if you have selected [All] or [Barcode] in the [Head Check] menu.
Every Page
Set the interval for head check.
◦ Appears only if you have selected [Every Page] in the [Head Check Mode] menu.
Check Media Size
Enable or disable media size check.
◦ Appears only if you have selected [Gap] or [I-Mark] in the [Sensor Type] menu.
Adjustments
Correct the offset value, print position and print darkness.
Start Online
Set whether to power on the printer in Online mode.
Feed After Error
Set whether to automatically feed the media when recovering from an error.
Feed At Power On
Set whether to automatically feed the media at power on.
Finisher Feed
Set the length to feed after printing.
Paper End
Select the sensor for sensing the paper end.
Head Base Position
Set the edge position for printing.
Prioritize
Select the prioritized setting.
Reprint
Enable or disable the reprint function.
Print End Position
Adjust the media stop position or cut position when [Sensor Type] is set to [None].
Label Near End
Enable or disable the warning when the media is about to run out.
*This feature is supported on printers from serial number 6B~ and above. Although this setting
appears on printers with serial number 6A~ or below, it is not supported.
233