Powering On/Off The Printer; Connecting The Power Cord - SATO CL4NX Operator's Manual

Powering On/Off the Printer

Connecting the Power Cord

• Do not touch the power button, connect or disconnect the power cord while your hands
are wet. Doing so could cause an electric shock.
• Always connect the ground wire to a ground terminal. Electric shock could occur if you
do not.
• Make sure that the AC voltage of your region is in the range of AC 100 - 240 V, 50 -
60 Hz. If your local voltage is not in the stated range, contact your SATO reseller or
technical support center.
• The attached power cord is designed exclusively for this printer. Do not use it with
other devices.
1. Connect the power cord to the AC input terminal (1) at the rear of the printer.
Take note of the orientation of the connector. Secure the printer with one hand, and insert the
connector tightly.
2. Insert the power plug into an AC outlet.
* The shape of the power plug varies depending on the region in which it was purchased.
67