SATO CL4NX Operator's Manual page 719

How to See the Command Error Information
Location of error occurrence
•
"Caaa" in the command error message shows the location of command error.
The number of ESC commands from ESC+A is shown in "aaa".
Note that the ESC+A command is not included in the number of ESC commands, which can be
shown up to 999.
When a command error is detected by the Horizontal Print Position <H> command.
------: [ESC]A
C001: [ESC]V100
C002: [ESC]H99999
C003: [ESC]L0202
C004: [ESC]M,ABCDEF
C005: [ESC]Q1
C006: [ESC]Z
In this case, C002 is the location of the error.
• Error command name
The command name is shown in "<bb>". Error is detected in the command name.
◦ A one-byte command name is left aligned
• Error description
The cause of command error appears in "cc" in the error message ("Caaa:<bb>:cc").
Description ("cc")
Invalid command
Invalid parameter
Command table read
error
Invalid graphic data/
custom designed data
Invalid registration
area
This number is
already registered.
Over registration area
limit
Data is not registered
Cause
Analyzed improper command.
Received improper parameter.
Failed to read the command table.
Analyzed improper graphic and custom designed data.
• Specified memory area (card slot) is inappropriate.
• Tried to write to a write-protected media.
Number specified by registration command has already been taken.
Exceeded the registration area. (Memory full)
Data is not registered.
719