SATO CL4NX Operator's Manual page 365

[PIN 5]
[PIN 7]
• You cannot set any inputs using the same pin number. If you attempt to set the same
number, the settings will be shown in red and you cannot save the settings.
[Outputs]
If the mode is other than RFID mode
If RFID mode is enabled (CL4NX only)
Set the output pin No. of the signals.
Press the /
buttons to change the pin No.
Press the
The setting items are as follows:
Paper End
Set the Signal Reprint to pin 5.
Set the Signal Reprint to pin 7.
buttons to highlight the item that you want to change, and press the
button to save the settings and return to the [Signals] menu.
365
/