Utility-Diagnosis; Utility-Diagnosis-Card Diagnosis - Panasonic KX-NS1000 Pc Programming Manual

7.1.1 Utility—Diagnosis—Card Diagnosis
7.1 Utility—Diagnosis
7.1.1 Utility—Diagnosis—Card Diagnosis
Performs diagnostic tests on cards installed in the PBX, to identify the source of problems.
If any of the tests listed here returns the result "NG" ("No Good"), contact your dealer.
When testing is complete, any cards that were set to OUS status must be returned to INS status if they are to
be used again.
This screen can be accessed only in On-line mode.
Card Test
Tests the relevant functions of a card to ensure that it is operating correctly. The tests carried out vary according
to the type of card being tested.
The tests that are performed on each card are listed below.
Note
Tests marked with a "*" are available only for cards installed on a legacy gateway. For details, see 9.28 PBX
Configuration—[1-1] Configuration—Slot—Legacy-GW1/Legacy-GW2. For more information about
cards installed in legacy gateways, refer to the documentation of the legacy gateway PBX.
Test Type
Local loop back diagnosis
Card CT Bus diagnosis*
DTMF Receive test port
PT loop back diagnosis*
DSP DTMF generator/receiver
diagnosis*
DSP DTMF receiver diagnosis*
Framer IC alarm signal detection
diagnosis*
Framer IC error detection diagnosis
114 PC Programming Manual
KX-NS1000 PBXs:
SLC2, LCOT2, PRI
Legacy Gateways:
DHLC, DLC, SLC8, SLC16, MSLC16, ESLC16, EMSLC16,
CSLC16, MCSLC16, ECSLC24, MCSLC24, CSIF, LCOT8,
LCOT16, ELCOT, T1, PRI, OPB
DHLC, DLC, SLC8, SLC16, MSLC16, EMSLC16, CSLC16,
ECSLC24, CSIF, LCOT, ELCOT, T1, PRI, OPB
KX-NS1000 PBXs:
SLC2
Legacy Gateways:
DHLC, SLC8, SLC16, MSLC16, MCSLC16, ESLC16, EMSLC16,
CSLC16, ECSLC24, MCSLC24
DHLC, DLC
T1
T1
T1, PRI
KX-NS1000 PBXs:
PRI
Legacy Gateways:
T1, PRI
Available Cards
Document Version 2016-03