Panasonic KX-NS1000 Pc Programming Manual page 81

4.
Click on another PBX site tab to program another PBX in the One-look network as required, and then repeat
steps 1–3. Perform settings for each PBX in the One-look network as required.
5.
Click Execute.
The program files are updated to the specified PBXs.
Note
•
Updated PBXs reset when the update is complete.
•
If this operation is performed when logged in to a Slave unit only the PBX mother board and
hardware specifically registered to the Slave unit may be updated.
Timed Update (Automatic update)
Specify which cards or devices to update and a time to execute the update.
1.
In Email notification, specify up to 2 e-mail addresses that will receive a notification when program files
have been updated.
2.
Updated program files that can be used to update cards or devices installed in the system are listed in
Available Program File(s). In Select the target to update, specify which cards or devices will be updated
using the files listed by checking the boxes next to each item.
Note
When selecting an item, a warning message may be displayed. Confirm the contents of the warning,
and then click OK to continue.
3.
In Update Time, specify the time of day when the update will be executed.
4.
Click Apply.
5.
Click on another PBX site tab to program another PBX in the One-look network as required, and then repeat
steps 1–4. Perform settings for each PBX in the One-look network as required.
6.
Click Execute.
The program files will be updated to the specified PBXs at the specified time.
Note
•
In a One-look network, the following processing is performed after you click Confirm:
1.
If you are updating the PBX's software, the check boxes are checked for all sites where the update
will be applied.
2.
A general check of the software version of all sites is performed.
•
When updating the software of devices other than the PBX (i.e., terminal devices), individually select
the check boxes for sites where the update will be applied.
•
All PBXs in a One-look network must be using the same version of the software. When updating PBXs
connected in a One-look network, note the following:
–
To confirm the software version of each site, click Confirm. Major and minor software versions are
displayed as follows:
Software version: XXX.YYY
XXX = Major version
YYY = Minor version
–
If all sites are the same software version, Apply is available and the settings will be applied for all
sites. If all sites are not the same software version, Apply is not available.
–
When updating the program files for multiple PBXs, an immediate (manual) update is
recommended. For Automatic (timed) updates, set the same Update Time for all PBXs in the
One-look network.
•
At most, the process of updating all PBXs in the network can take approximately 30 minutes to
complete.
•
For CS program files, in order for CS cards to be displayed on this screen, the cards must be set to
INS, and the ports of the card must be set to OUS.
Document Version 2016-03
5.1.2 System Control—Program Update—Update Program File
PC Programming Manual 81