System Control-Program Update-Update Program File - Panasonic KX-NS1000 Pc Programming Manual

5.1.2 System Control—Program Update—Update Program File
5.1.2 System Control—Program Update—Update Program File
Once updated program files have been downloaded and are stored on a PBX, they can be used to update the
system files of the PBX. The update process can be set to be automatically performed at a specified time, or
the update process can be carried out manually.
You must be connected to the PBX in On-line mode to update program files.
Note
•
Before updating program files, we strongly recommend making a backup of all system files. For details,
refer to the following:
–
6.1 Tool—System Data Backup
–
6.8 Tool—UM Data Backup
•
Do not upgrade KX-UT series SIP phones at the same time as the Main unit.
•
When upgrading the system software to version 004.1xxxx from an older version, the following SRAM
data is cleared.
–
Timed Reminder
–
Remote Station Lock Status
–
Room Status
–
Login/Logout Status
–
SMDR
–
Hotel Check In/Check Out
–
Hotel Specifications
Save SRAM data before upgrading the firmware.
When you upgrade the software, a message will be shown. Then, you can save the following SRAM
data into the Storage Memory Card as "smdrdata.zip".
–
SMDR
–
Hotel Specifications
•
When upgrading the firmware for the Unified Messaging (UM) Program (PFAX), specify the MPR card
as the target hardware. The MPR card's firmware will be updated at the same time. Be aware that a
system reset is necessary when performing the upgrade. However, to update the MPR card's firmware
at the same time as the PFAX firmware, Immediately (Manual update) must be selected for Program
Update Type. If Timed Update (Automatic update) is selected, the PFAX firmware will not be updated
at the same time.
For Program Update Type, select Immediately or Timed Update.
Immediately (Manual update)
Specify which cards or devices to update, and perform the update immediately.
1.
In Email notification, specify up to 2 e-mail addresses that will receive a notification when program files
have been updated.
2.
Updated program files that can be used to update cards or devices installed in the system are listed in
Available Program File(s). In Select the target to update, specify which cards or devices will be updated
using the files listed by checking the boxes next to each item.
Note
•
When selecting an item, a warning message may be displayed. Confirm the contents of the warning,
and then click OK to continue.
•
If you are updating the software for a PS, select the port of an IP-CS (e.g., KX-NS0154) that
supports this feature. For details about which PSs can be updated, see 5.1.3 System
Control—Program Update—Plug and Update.
3.
Click Apply.
80 PC Programming Manual Document Version 2016-03