Cisco ASR 9000 Series Command Reference Manual page 1127

10-Gigabit Ethernet WAN PHY Controller Commandson the Cisco ASR 9000 Series Router
Table 65: show controllers wanphy Command Output Fields
Field
Interface
Configuration Mode
SECTION
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
show controllers wanphy
Description
Identifies the WAN physical interface, in the format
rack/slot/module/port.
• rack: Chassis number of the rack.
• slot: Physical slot number of the line card.
• module: Module number. A physical layer
interface module (PLIM) is always 0. Shared
port adapters (SPAs) are referenced by their
subslot number.
• port: Physical port number of the interface.
Current configuration mode running on this controller.
Can be WAN mode or LAN mode.
Displays the following section alarms:
• LOF—Number of Loss of Framing (LOF) errors
on this connection section. LOF alarms are
critical because they indicate that the link
associated with this section is down.
• LOS—Number of loss of signal (LOS) errors
on this connection section. LOS alarms are
critical because they indicate that the link
associated with this section is down.
• BIP(B1)—Number of bit interleaved parity
(BIP) B1 errors on this section that exceeded
the specified threshold.
Release 5.3.x
1107