Show Ptp Port - Cisco nexus 3000 series Command Reference Manual

show ptp port

S e n d c o m m e n t s t o n e x u s 3 k - d o c f e e d b a c k @ c i s c o . c o m
show ptp port
To display information about the Precision Time Protocol (PTP) port, use the show ptp port command.
Syntax DescriptionT
interface
ethernet slot/port
Command Default None
Command Modes Any command mode
Command History Release
5.0(3)U2(2)
Usage Guidelines This command does not require a license.
Examples This example shows how to display information about the PTP port on the Ethernet interface 1/5:
switch# show ptp port interface ethernet 1/5
PTP Port Dataset: Eth1/5
Port identity: clock identity:
Port identity: port number: 4
PTP version: 2
Port state: Disabled
VLAN info:
Delay request interval(log mean): 2
Peer mean path delay: 0
Announce interval(log mean): 1
Sync interval(log mean): -2
Delay Mechanism: End to End
Peer delay request interval(log mean): 0
switch#
Cisco Nexus 3000 Series NX-OS System Management Command Reference
-SM-258
show ptp port interface ethernet slot/port
Specifies the interface.
Specifies an IEEE 802.3z Ethernet interface. The slot number is from 1 to
255 and the port number is from 1 to 128.
Modification
This command was introduced.
1
0: 5:73:ff:ff:ff:5b: 1
Chapter System Management Commands
OL-29557-04