Show Lacp - Cisco Catalyst 4500 Series Configuration Manual

Chapter 2

show lacp

To display LACP information, use the show lacp command.
Syntax Description
channel-group
counters
internal
neighbors
sys-id
Command Default
This command has no default settings.
Command Modes
Privileged EXEC mode
Command History Release
12.1(13)EW
Usage Guidelines
If you do not specify a channel-group value, all channel groups are displayed.
You can enter the optional channel-group value to specify a channel group for all keywords, except the
sys-id keyword.
Examples
The following example shows how to display LACP statistical information for a specific channel group:
Switch# show lacp 1 counters
Port
---------------------------------------------------
Channel group: 1
Fa4/1
Fa4/2
Fa4/3
Fa4/4
Switch#
The output displays the following information:
•
•
show lacp [channel-group] {counters | internal | neighbors | sys-id}
(Optional) Number of the channel group; valid values are from 1 to 64.
Displays the LACP statistical information.
Displays the internal information.
Displays the neighbor information.
Displays the LACP system identification.
Modification
This command was introduced on the Catalyst 4500 series switches.
LACPDUs
Sent Recv
8 15
14 18
14 18
13 18
The LACPDUs Sent and Recv columns display the LACPDUs sent and received on each specific
interface.
The LACPDUs Pkts and Err columns display the marker protocol packets.
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
Marker LACPDUs
Sent Recv Pkts Err
0 0 3 0
0 0 3 0
0 0 0
0 0 0
show lacp
2-845